Whirlpool Washer & Dryer Manuals

Most Common Error Codes (All Models)

• F8 E1 / LF / LO FL: No water detected – check water valves open; clean inlet screens; replace inlet valve.
• F8 E2: Dispenser error – clean dispenser drawer; check hose not kinked.
• F7 E1 / Sd / 5d: Excessive suds or drain issue – use only HE detergent; clean drain pump filter.
• F5 E2 / F5 E3: Lid/door lock fault – clean lock area; replace lid lock assembly (very common).
• F9 E1 / Ld: Long drain – clean pump filter (coin trap); check drain hose height (max 96").
• F0 E1: Load detected during Clean Washer cycle – remove clothes and rerun.

Top Load Impeller & Agitator Models

• Won’t spin / UL error: Unbalanced load – redistribute; run calibration mode (hold “Start” 3 sec → turn knob to “Done” → press Start).
• Shifting noise / grinding: Failing shift actuator or splutch (direct-drive models 2010+).

Front Load (Duet, Maytag Maxima, etc.)

• Mold smell: Run Affresh or Clean Washer cycle monthly; leave door ajar.
• Shaking / walking: Level the feet; use anti-vibration pads; tighten shipping bolts removed.

Dryer Specific

• No heat (electric): Check 240V breaker; clean vent duct yearly; replace thermal fuse if blown.
• AF (low airflow): Clean lint screen & vent; replace restricted duct.

Safety note: Always unplug before cleaning pump filter or internal parts. Never bypass lid/door switch.