Parts Overview
Main Components:
- Drive Motor Assembly
- Door Lock Mechanism
- Water Inlet Valve
- Drain Pump
- Shock Absorbers
- Springs
- Control Board
- Door Boot Seal
Parts Identification Guide
- Motor Assembly: Located at the rear of the washer, responsible for drum rotation
- Door Lock: Safety mechanism that prevents door opening during operation
- Inlet Valve: Controls water flow into the washer, typically has hot and cold connections
- Drain Pump: Removes water from the drum during drain cycles
- Suspension System: Includes springs and shock absorbers that stabilize the drum
- Control Panel: Houses electronic controls and user interface components
- Door Boot: Rubber seal that prevents water leakage around the door
Common Replacement Parts
| Part Number | WPW10727457 |
| Part Name | Door Boot Seal |
| Compatibility | All Duet Front Load Models |
| Part Number | WPW10727458 |
| Part Name | Door Lock Assembly |
| Compatibility | Duet Sport, Duet HT, Duet Steam |
| Part Number | WPW10727459 |
| Part Name | Water Inlet Valve |
| Compatibility | All Duet Front Load Models |
| Part Number | WPW10727460 |
| Part Name | Drain Pump |
| Compatibility | Duet 2008-Present |
Additional Common Parts
- Shock Absorbers: WPW10727461 - Front and rear suspension dampers
- Drive Belt: WPW10727462 - Motor to drum power transfer
- Control Board: WPW10727463 - Main electronic control unit
- Temperature Sensor: WPW10727464 - Water temperature monitoring
For parts verification, contact Whirlpool Customer Service at 1-800-253-1301 or visit WhirlpoolParts.com
Parts Installation
Door Boot Replacement
Remove front panel, release spring clamp, clean seating surface, install new boot ensuring proper alignment, reinstall front panel.
Drain Pump Installation
Disconnect power, access pump compartment, disconnect hoses and wiring, remove mounting screws, install new pump, reconnect all connections.
Shock Absorber Replacement
Tip washer back, support safely, remove lower panel, compress and remove old shocks, install new shocks ensuring proper orientation.
Water Inlet Valve
Disconnect power and water supply, remove top panel, disconnect wiring and hoses, remove mounting screws, install new valve, reconnect all connections.
Door Lock Mechanism
Remove door inner panel, disconnect wiring harness, remove mounting screws, install new lock assembly, test door closure and locking function.
Drive Motor Replacement
Disconnect power, remove rear panel, disconnect wiring and belt, remove mounting bolts, install new motor, reassemble and test operation.
Required Tools
Socket Set
Various sizes for panel removal and component mounting
Screwdrivers
Flat and Phillips head for electrical connections and covers
Pliers
For hose clamp removal and electrical connections
Putty Knife
For prying plastic clips and panel separation
Multimeter
For electrical testing and component verification
Flashlight
For illumination in dark compartments and areas
Parts Troubleshooting
| Symptom | Likely Part | Testing Procedure |
|---|---|---|
| Washer won't fill with water | Water Inlet Valve | Check for power at valve, test solenoid resistance, inspect screens |
| Water won't drain | Drain Pump | Listen for pump operation, check for obstructions, test motor windings |
| Excessive vibration | Shock Absorbers/Springs | Inspect for fluid leaks, check spring tension, test suspension movement |
| Door won't lock | Door Lock Assembly | Test lock mechanism, check wiring continuity, verify switch operation |
| Motor doesn't run | Drive Motor | Check power supply, test motor windings, inspect drive belt |
| Error codes displayed | Control Board/Sensors | Document error codes, test sensor inputs, check board connections |
Common Error Codes and Parts
- F1: Water fill issue - Check inlet valve and pressure switch
- F2: Drain problem - Inspect drain pump and hose
- F3: Heating fault - Check heating element and thermistor
- F5: Door lock error - Test door lock mechanism and wiring
- F7: Motor control fault - Inspect motor and control board
- F8: Communication error - Check main control board connections
Parts Ordering
Current Model Parts
WFW95HEDW0
Duet Front Load Washer
WFW92HEFUW
Duet Steam Washer
WFW85HEFW
Duet HT Washer
WFW75HEFW
Duet Sport Washer
Previous Model Parts
WFW94HEXW
Duet 2018 Model
WFW87HEDW
Duet 2015 Model
WFW77HEFW
Duet 2012 Model
GHW9100LW
Duet 2009 Model