Whirlpool Washer Model WTW4816FW3 Manual

The Whirlpool WTW4816FW3 is a top-loading washing machine with a 3.5 cu. ft. capacity, featuring an IMPELLA™ wash system, 10 wash cycles, 5 soil levels, 4 spin speeds, and 4 temperature selections. It includes a Deep Water Wash option, a stainless steel wash basket, and an ENERGY STAR® qualified design for efficiency. Below are key sections for safety, features, installation, setup, operation, care, and troubleshooting.

Features at a Glance

Key components: Control Panel, IMPELLA™ Wash Plate, Stainless Steel Basket, Lid, Water Inlet Hoses, Drain Hose, Power Cord.

Installation

Unpack and inspect contents. Place on a level, solid floor.

1. Remove shipping materials: Take out cardboard base, foam blocks, and tape.
2. Level the washer: Adjust the leveling legs to prevent vibration and movement.
3. Connect water supply: Attach hot and cold water hoses to faucets and inlet valves.
4. Connect drain hose: Secure to standpipe or laundry tub.
5. Plug into a grounded 120V AC, 60 Hz outlet.

WARNING! Do not remove the shipping bolts until the washer is in its final location. Ensure water connections are tight to prevent leaks.

First-Time Setup

After installation, run an initial cleaning cycle.

1. Remove shipping bolts: Use wrench to remove bolts from rear panel; install plastic caps.
2. Check level: Rock washer corner to corner; adjust legs if it rocks.
3. Run a Clean Washer cycle: Add a washing machine cleaner or bleach and run on the Clean Washer setting (if available) or a Normal cycle with hot water.
4. Familiarize with controls: Review cycle guide and settings.

CAUTION! The washer is heavy; use caution when moving. Do not install on carpet.

Specifications

• Model: WTW4816FW3
• Type: Top-Load Agitator Washer
• Capacity: 3.5 cubic feet
• Color: White
• Control Type: Electronic with Rotary Dial
• Wash Cycles: 10 (Normal, Heavy, Delicates, Quick Wash, Bulky Items, Hand Wash, Rinse & Spin, Drain & Spin, Clean Washer, Soak)
• Water Temperature: Cold, Cool, Warm, Hot
• Spin Speeds: Delicate, Medium, High, No Spin
• Soil Levels: Light, Normal, Heavy, Extra Heavy, Max
• Power Requirements: 120V AC, 60 Hz, 15 Amp
• Water Pressure: 20-120 psi
• Dimensions (HxWxD): Approximately 43.5" x 27" x 27.5"

Controls and Settings

Control Panel: Rotary Cycle Selector Knob, Start/Pause Button, Options Buttons (Soil Level, Spin Speed, Temp, Deep Water), Display.

Cycle Selector: Turn to choose a wash cycle. The display shows estimated time.

Options: Press corresponding button to cycle through settings:
Soil Level: Light, Normal, Heavy, Extra Heavy, Max.
Spin Speed: Delicate, Medium, High, No Spin.
Temp: Cold, Cool, Warm, Hot.
Deep Water: On/Off for selected cycles.

Start/Pause: Press to start or pause a cycle. Lid must be closed to start.

Delay Start: Press Delay Start button, then use +/- to set hours (1-12).

Connecting Water Supply

Hot and Cold water inlets on back. Use provided hoses or new 5/8" standard hoses.

1. Turn off water faucets.
2. Connect hoses: Hand-tighten hoses to faucets and washer inlet valves (H=Hot, C=Cold).
3. Turn on water: Slowly open faucets and check for leaks.
4. Run water: Briefly run into a bucket to clear debris from lines.

Tip: Use thread seal tape on hose threads for a better seal. Do not overtighten.

Using Wash Cycles

Follow these steps for washing clothes.

1. Load laundry: Do not overload. Mix large and small items.
2. Add detergent: Pour into detergent dispenser. Use HE detergent.
3. Add bleach/fabric softener: Use appropriate dispensers.
4. Select cycle: Turn knob to desired cycle (e.g., Normal for cottons).
5. Select options: Press buttons to set Soil Level, Spin Speed, Temp, and Deep Water as needed.
6. Start: Close lid and press Start/Pause.
7. Pause/Add item: Press Start/Pause to pause; you can add a forgotten item within a few minutes.
8. End of cycle: Washer will beep. Remove clothes promptly to prevent wrinkles.

WARNING! Do not wash items soiled with flammable substances. Balance loads to reduce vibration.

Special Features

Deep Water Wash: Adds more water for heavily soiled loads or bulky items. Select cycle, then press Deep Water button.

Delay Start: Set washer to start later. Useful for off-peak energy hours.

Clean Washer Cycle: Runs a cleaning cycle with hot water and cleaner to remove residue. Run monthly.

Quick Wash Cycle: Washes a small load in about 30 minutes.

Care & Cleaning

Unplug before cleaning. Wipe exterior with a damp cloth. Clean interior monthly.

1. Clean basket: Run Clean Washer cycle or a hot water cycle with washer cleaner.
2. Clean dispensers: Remove and rinse under warm water.
3. Clean lid: Wipe with soft cloth.
4. Inspect hoses: Check for cracks or leaks annually; replace every 5 years.

CAUTION! Do not use abrasive cleaners or solvents. Keep control panel dry.

Regulatory Information

This appliance complies with FCC Part 15. It may not cause harmful interference and must accept any interference received. Manufactured under license from Whirlpool Corporation. For support, visit www.whirlpool.com or contact 1-800-253-1301. ENERGY STAR is a registered trademark of the U.S. EPA.

Troubleshooting

Reset: Unplug washer for 1 minute to reset control.

Service: 1-800-253-1301; www.whirlpool.com